lcd_hx8347.c

Go to the documentation of this file.

/* ----------------------------------------------------------------------------
 *         ATMEL Microcontroller Software Support
 * ----------------------------------------------------------------------------
 * Copyright (c) 2010, Atmel Corporation
 *
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions are met:
 *
 * - Redistributions of source code must retain the above copyright notice,
 * this list of conditions and the disclaimer below.
 *
 * Atmel's name may not be used to endorse or promote products derived from
 * this software without specific prior written permission.
 *
 * DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR
 * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
 * MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE
 * DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT,
 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
 * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,
 * OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
 * LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
 * NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
 * EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 * ----------------------------------------------------------------------------
 */

#include "lcd_hx8347.h"

#include "hw/hw_hx8347.h"
#include <cfg/debug.h>
#include <drv/timer.h>

// Himax HX8347 chip id
#define HX8347_ID_HIMAX  0x47


static uint16_t lcd_row[LCD_WIDTH];


struct lcd_hx8347_reg
{
    uint8_t cmd;    // Register index, if 0xFF wait for value ms
    uint8_t data;   // Register value
};

static const struct lcd_hx8347_reg init_seq[] =
{
    // Start internal OSC
    { 0x19, 0x49 },   // OSCADJ=10 0000, OSD_EN=1 //60Hz
    { 0x93, 0x0C },   // RADJ=1100

    // Power on flow
    { 0x44, 0x4D },   // VCM=100 1101
    { 0x45, 0x11 },   // VDV=1 0001
    { 0x20, 0x40 },   // BT=0100
    { 0x1D, 0x07 },   // VC1=111
    { 0x1E, 0x00 },   // VC3=000
    { 0x1F, 0x04 },   // VRH=0100

    { 0x1C, 0x04 },   // AP=100
    { 0x1B, 0x10 },   // GASENB=0, PON=1, DK=0, XDK=0, DDVDH_TRI=0, STB=0
    { 0xFF, 50   },   // 50 ms delay

    { 0x43, 0x80 },   // Set VCOMG=1
    { 0xFF, 50   },   // 50 ms delay

#if 0
    // Gamma for CMO 2.8
    { 0x46, 0x95 },
    { 0x47, 0x51 },
    { 0x48, 0x00 },
    { 0x49, 0x36 },
    { 0x4A, 0x11 },
    { 0x4B, 0x66 },
    { 0x4C, 0x14 },
    { 0x4D, 0x77 },
    { 0x4E, 0x13 },
    { 0x4F, 0x4C },
    { 0x50, 0x46 },
    { 0x51, 0x46 },
#endif

    // 240x320 window setting
    { 0x02, 0x00 },   // Column address start2
    { 0x03, 0x00 },   // Column address start1
    { 0x04, 0x00 },   // Column address end2
    { 0x05, 0xEF },   // Column address end1
    { 0x06, 0x00 },   // Row address start2
    { 0x07, 0x00 },   // Row address start1
    { 0x08, 0x01 },   // Row address end2
    { 0x09, 0x3F },   // Row address end1

    // Display Setting
    { 0x01, 0x06 },   // IDMON=0, INVON=1, NORON=1, PTLON=0
//  { 0x16, 0xC8 },   // MY=1, MX=1, MV=0, BGR=1
    { 0x16, 0x68 },   // MY=0, MX=1, MV=1, RGB XY exchange X mirror
    { 0x23, 0x95 },   // N_DC=1001 0101
    { 0x24, 0x95 },   // P_DC=1001 0101
    { 0x25, 0xFF },   // I_DC=1111 1111
    { 0x27, 0x06 },   // N_BP=0000 0110
    { 0x28, 0x06 },   // N_FP=0000 0110
    { 0x29, 0x06 },   // P_BP=0000 0110
    { 0x2A, 0x06 },   // P_FP=0000 0110
    { 0x2C, 0x06 },   // I_BP=0000 0110
    { 0x2D, 0x06 },   // I_FP=0000 0110
    { 0x3A, 0x01 },   // N_RTN=0000, N_NW=001
    { 0x3B, 0x01 },   // P_RTN=0000, P_NW=001
    { 0x3C, 0xF0 },   // I_RTN=1111, I_NW=000
    { 0x3D, 0x00 },   // DIV=00
    { 0x3E, 0x38 },   // SON=38h
    { 0x40, 0x0F },   // GDON=0Fh
    { 0x41, 0xF0 },   // GDOF=F0h
};

/*
 * Write to an LCD register.
 */
static void regWrite(uint8_t reg, uint16_t val)
{
    hx8347_cmd(reg);
    hx8347_write(val);
}

/*
 * Read data from a LCD register.
 */
static uint16_t regRead(uint8_t reg)
{
    hx8347_cmd(reg);
    return hx8347_read();
}

/*
 * Write data in a buffer to the LCD controller.
 */
static void bufferWrite(const uint16_t *buf, uint16_t size)
{
    uint16_t i;
    for (i = 0 ; i < size; ++i)
        hx8347_write(buf[i]);
}

static void lcd_setCursor(uint16_t x, uint16_t y)
{
    regWrite(0x02, x >> 8);
    regWrite(0x03, x & 0xff);
    regWrite(0x06, y >> 8);
    regWrite(0x07, y & 0xff);
}

static void lcd_setWindow(uint16_t x, uint16_t y, uint16_t width, uint16_t height)
{
    ASSERT(x + width <= LCD_WIDTH);
    ASSERT(y + height <= LCD_HEIGHT);
    ASSERT(width > 0);
    ASSERT(height > 0);

    // Window right and bottom limits are inclusive
    width--;
    height--;

    lcd_setCursor(x, y);

    regWrite(0x04, (x + width) >> 8);
    regWrite(0x05, (x + width) & 0xff);
    regWrite(0x08, (y + height) >> 8);
    regWrite(0x09, (y + height) & 0xff);
}

/*
 * Refresh a bitmap on screen
 */
void lcd_hx8347_blitBitmap(const Bitmap *bm)
{
    uint8_t mask;
    int i, l, r;

    lcd_setWindow(0, 0, bm->width, bm->height);
    hx8347_cmd(0x22);

    for (l = 0; l < bm->height / 8; l++)
    {
        for (mask = 1; mask; mask <<= 1)
        {
            for (i = 0; i < bm->width; i++)
            {
                if (bm->raster[l * bm->width + i] & mask)
                    lcd_row[i] = 0x0000;
                else
                    lcd_row[i] = 0xFFFF;
            }
            bufferWrite(lcd_row, bm->width);
        }
    }

    for (r = 0, mask = 1; r < bm->height % 8; r++, mask <<= 1)
    {
        for (i = 0; i < bm->width; i++)
        {
            if (bm->raster[l * bm->width + i] & mask)
                lcd_row[i] = 0x0000;
            else
                lcd_row[i] = 0xFFFF;
        }
        bufferWrite(lcd_row, bm->width);
    }
}

/*
 * Blit a 24 bit color raw raster directly on screen
 */
void lcd_hx8347_blitBitmap24(int x, int y, int width, int height, const char *bmp)
{
    int l, r;

    lcd_setWindow(x, y, width, height);
    hx8347_cmd(0x22);

    for (l = 0; l < height; l++)
    {
        for (r = 0; r < width; r++)
        {
            lcd_row[r] =
                (((uint16_t)bmp[0] << 8) & 0xF800) |
                (((uint16_t)bmp[1] << 3) & 0x07E0) |
                (((uint16_t)bmp[2] >> 3) & 0x001F);
            bmp += 3;
        }
        bufferWrite(lcd_row, width);
    }
}

void lcd_hx8347_off(void)
{
    regWrite(0x90, 0);  // SAP=0000 0000
    regWrite(0x26, 0);  // GON=0, DTE=0, D=00
}

void lcd_hx8347_on(void)
{
    regWrite(0x90, 0x7F);  // SAP=0111 1111
    regWrite(0x26, 0x04);  // GON=0, DTE=0, D=01
    timer_delay(100);
    regWrite(0x26, 0x24);  // GON=1, DTE=0, D=01
    regWrite(0x26, 0x2C);  // GON=1, DTE=0, D=11
    timer_delay(100);
    regWrite(0x26, 0x3C);  // GON=1, DTE=1, D=11
}

void lcd_hx8347_init(void)
{
    unsigned i;
    uint16_t chip_id;

    hx8347_busInit();
    lcd_hx8347_off();

    // Check chip id
    if ((chip_id = regRead(0x67)) != HX8347_ID_HIMAX)
    {
        kprintf("HX8347 chip id read error or wrong id (0x%x), skipping initialization.\n", chip_id);
        return;
    }

    for (i = 0; i < countof(init_seq); i++)
    {
        if (init_seq[i].cmd != 0xFF)
            regWrite(init_seq[i].cmd, init_seq[i].data);
        else
            timer_delay(init_seq[i].data);
    }

    lcd_hx8347_on();
}